Slack Lack - The Lack Enclosure with Sliding Pocket Doors
by nnorton00
About this model
See Video: https://www.youtube.com/watch?v=ctuxhp6h6kc The Slack Lack was greatly influenced by the Original Prusa Enclosure found here: https://www.thingiverse.com/thing:2864118 That being said, all of the design and CAD for this enclosure is my own. I wanted an enclosure for printing ABS but I also wanted to be able to leave the front open when printing PLA. I didn't want to have to leave the doors wide open as this sits in my living room, I knew I wanted pocket doors. It is designed to be tall enough to hold an Ender 3 and a 30mm tall paving stone (helps in vibration reduction). The total usable height is 50cm. The doors hinge shut and latch via magnets. There are also support magnets in the hinge peices that prevent it from sliding while opening and closing the doors normally. The doors will slide back on tracks into the enclosure out the way. Finally, the doors ca
Description excerpted from the original listing.